With this and the other recommendations below, your aim will be more in sync with your shooting.īy default, this move is set to 元, but by setting it to L1, you’ll be able to perform quick leaning to the left much easier, because you won’t need to put pressure on the left analog stick anymore.īy default, this move is set to R3, but with O, you’ll be able to do a quick lean and perform a quick scan without having to put pressure on the right analog stick. You should put the aim action into 元 instead. With this, you can shoot while also adjusting your aim.īy default, R2 is for shooting, but since it’s better to put the shooting action in R3, I recommend just putting the unique ability/primary gadget action into R2.īy default, 元 is for leaning left, but since it’s better to put the lean left action to L1 because that’ll be much easier. That is why it’s best to assign R3 for shooting. But putting pressure on the right analog stick just to lean can affect your quick lean negatively. Usually when you’re aiming down your sights, you’re already expecting to fire in one direction, so having a high value for this will only affect your recoil negatively.īydefault, R3 is for leaning right. It is not recommended to make the value of ADS sensitivity higher than 45, because when you’re on ADS, it would be very rare for you to have to adjust your aim drastically. So, keep this setting at its smallest value which is 5. Meaning you would want your aim to move as soon as you move your right analog stick. You would want it to be as sensitive as it can be. Since the right analog stick in R6 is for looking. And because in R6, the left analog stick is usually for moving, keep this value a bit higher to lessen the moments you move by mistake. It’s basically the amount your analog stick can move before the command is recognized in the game. So, give this setting as high a value as you can control.ĭead Zone in controllers is kind of like their sensitivity. That’s also where most enemies will appear on your sight. This is where you would want a high value because most encounters in R6 will require you to have fast reflexes when it comes to looking left or right. Keep this low and it’ll help you keep your cursor placement in place. T-Hunt is a good place to train your cursor placement, especially if you enable Headshots Only, so better practice there with the same aim settings as in multiplayer.Īlways keep this value lower than the Horizontal Sensitivity because most of the time in R6 encounters, you won’t really need drastic changes in your vertical look. It only works in Terrorist Hunt/Training Grounds and it’s really not good for practicing your aim if there are times that you’ll have a T-Hunt/Training Grounds run with Aim Assist enabled. It’s not good, especially when you’re planning to play R6 for a long time. I prefer to have this disabled because the vibration can sometimes affect my aim negatively and it just tires my hand faster.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |